How to use TrackStraps:

First, clear away any excess or loose dirt from around your tire.

Next, Place your traction board on the ground, a few inches in front of your tire:

To set up your straps, thread the tail of one of them through 2 links, and slide the links towards the end with the D-rings:

Toss the tail end of your strap around the inside of your tire, so it comes out the back:

Insert the links into the mounting holes on your traction boards:

Now take the tail of your strap, bring it around the front of your tire, and secure it to the D-rings by passing it through both of them, then back through one:

Next, thread a second strap through the back of your first one, and wrap the end with the D-rings around and over your tire. Secure it the same way as the first one:

Make sure that the links are spread apart and that your traction board is up tight against the tire:

Tighten the Bottom strap first, then the top one. Make sure that each strap contains roughly 1/3 of the tire:

Now the magic part: after setting up both tires, drive forward slowly and stop after the links have pulled you onto the traction board and disengaged:

Before continuing, simply pull the straps off of your tire and lay them on the ground:

That’s it!